Porsche 996 / 996 GT3 / 986 Recaro Seat Trim Kit

Fits without modification

Made for the bucket seats fitted to the Porsche 996, 996 GT3 and 986 Boxster. Each bezel is reverse-engineered from an original part, so the mounting points, belt aperture and seat-back curvature land exactly where the factory ones do. Drop-in — no trimming, drilling or shimming.

Looks right in the car

Black Matte is finished to sit alongside your existing interior trim rather than stand out against it — the same low-sheen surface the factory bezel had when new, before it went grey and scuffed. Glossy Black gives a deep, high-shine finish that pairs with piano-black or gloss interior trim for a cleaner, more polished look. Carbon Fiber is the deliberate upgrade choice: a darker, textured surface that reads as a purposeful modification against black leather or Alcantara.

Built to outlast the original

Factory bezels crack. They sit in a high-friction, high-load position, and the original plastic goes brittle with age until a hard belt pull snaps a mounting tab.

These are made from PC-ABS — polycarbonate toughness blended with ABS impact resistance. Under a sharp load it flexes and returns instead of fracturing, and it holds its shape and dimensions in a hot cabin, so the bezel stays flush against the seat instead of lifting at the edges. The surface also resists the fine scratching that belt webbing works into softer plastics over time.

What you get

A complete set for both front seats — 4 bezels total, driver and passenger. Black mounting bolts are included so the set goes straight on without sourcing hardware separately.

Who makes it

Rigid Custom Works engineers replacement parts for cars the factory has stopped supporting. Every part starts from a measured original, gets redesigned around the failure point rather than copied with the flaw intact, and is produced in-house in Dubai under our own quality control.